Hardwood refinishing & sanding in Royse City, TX

If it is pier-and-beam with a plank subfloor, yes, and that is exactly what solid hardwood was made for. It is an option the new houses south of I-30 do not have. We screw the subfloor down first to stop squeaks, check for spring between the joists, and add plywood underlayment where the old planks are not flat. Then the hardwood gets nailed down the traditional way.

We shoot elevations at every doorway during the estimate rather than assuming they match. In a house that has been patched, leveled and added to for a century, the differences are real and they are not always visible. Once we have numbers we can plan the transitions properly, whether that means feathering the subfloor, using a reducer, or resetting a threshold, instead of improvising on the last day.

Yes. Waterscape, Creekshaw, Verandah and the rest of the FM 548 corridor are all in our area, and we come out from the Forney showroom with samples in the truck. Because Royse City runs across Rockwall, Collin and Hunt counties, give us the full address when you call (972) 564-5533 so we route the crew and the material delivery correctly.

You can, but the seam will show. The same species from the same era darkens at a different rate depending on light, and a fresh finish beside a fifteen-year-old one reads as new against old no matter how the stain is matched. Where a room closes off with a door, we stop cleanly at a threshold. Across an open plan, do the whole field.

Most families stay. With a waterborne finish the odor is mild and clears quickly, and we sequence the work so there is a path to a bedroom and a bathroom. Oil-modified finish is a different story: the smell is strong for several days, and households with infants or birds usually leave. Pets have to be out of the work area entirely, since paw prints in a curing finish are permanent.

Yes, within what the species allows. Red oak carries a pink undertone that fights gray stains, maple and birch blotch unless they are conditioned or water-popped first, and no stain makes a floor lighter than its own bare wood. We sand a section of your floor and lay candidate stains on it, because a sample board of someone else's oak tells you very little.