Hardwood refinishing & sanding in Terrell, TX

Pull a corner and look at the board thickness first. Solid boards from the 1880s to 1920s usually have plenty of material left and refinish beautifully. Replacement only makes sense if the boards are cupped past sanding, water-damaged near the exterior walls, or if too many are missing from old plumbing runs. We'll tell you honestly which you're looking at before you spend anything.

To a point, and we're straight about the limit. On a pier-and-beam house we can shim and sister joists, re-deck bad sections and bring the surface flat enough for plank or tile to sit right. What we can't do is correct a foundation that is still moving, that's a foundation contractor's job, and doing the floor first just means doing it twice.

Once the slab is dry enough to test clean, which we check rather than guess at. New Terrell slabs can still be giving off moisture months after pour, and that's what ruins a glue-down. Floating LVP is more forgiving and can often go in sooner. Estimates are free, we bring samples out, and we can usually start within about two days of you deciding.

You can, but the seam will show. The same species from the same era darkens at a different rate depending on light, and a fresh finish beside a fifteen-year-old one reads as new against old no matter how the stain is matched. Where a room closes off with a door, we stop cleanly at a threshold. Across an open plan, do the whole field.

Most families stay. With a waterborne finish the odor is mild and clears quickly, and we sequence the work so there is a path to a bedroom and a bathroom. Oil-modified finish is a different story: the smell is strong for several days, and households with infants or birds usually leave. Pets have to be out of the work area entirely, since paw prints in a curing finish are permanent.

Yes, within what the species allows. Red oak carries a pink undertone that fights gray stains, maple and birch blotch unless they are conditioned or water-popped first, and no stain makes a floor lighter than its own bare wood. We sand a section of your floor and lay candidate stains on it, because a sample board of someone else's oak tells you very little.