Stairs & trim in Forney, TX

Because builder allowances in the Forney master-planned communities usually cover entry-level carpet and a thin sheet vinyl in the wet areas. Neither is built for a decade of traffic. The slab underneath is usually fine, which is good news: once we grind the high spots and fill the low ones, a wear-layer LVP or engineered wood goes down over the same subfloor and lasts far longer.

Yes, but the prep is different. Pier-and-beam houses off the downtown streets typically have plank subfloors that have moved over decades. We stiffen and level the deck first, add underlayment where it's needed, then install. Expect the finished floor to sit slightly higher than the old one, which means door casings get undercut and interior doors may need trimming.

You're welcome to, the showroom is at 10 Mustang Court and it's a short drive from anywhere in Forney. But most people would rather see samples in their own light, next to their own cabinets and walls. Estimates are free and we bring samples to the house. Once you've decided, we can usually start within about two days.

Usually, if the product can be identified. Bring us a spare plank or a photo of the carton and we look for a nosing from the same line first. If it has been discontinued, a stain grade nosing finished on site gets closer than a stock profile in a similar color. We would rather say a true match is not achievable than install one that reads wrong on every step.

Most residential flights run two to three days once material is on hand, and the stairs are out of service for part of that. In a two story house with one staircase we sequence the work so the flight is walkable overnight, or split it and do half at a time. Tell us at the estimate if someone in the household cannot manage a detour.

No, and most people choose not to. White painted risers under a stained tread is the standard look in newer Dallas area homes and it ties the staircase back to the baseboard and casing already in the house. Matching stained risers give a darker, more solid result. Decide before the treads go down, because cutting paint in cleanly around finished treads is slow work.